QUICSEAL 102 ECO

QUICSEAL 102ECO is a single component, ready-to-use, Acrylic-polyurethane liquid applied waterproof membrane. QUICSEAL 102ECO comprises of special blend of copolymers and additives to provide an

excellent seamless, elastomeric and quick-drying waterproofing membrane.

Uses

QUICSEAL 102ECO is suitable for waterproofing (concealed) applications for the following areas:

•  Kitchens, toilets, balconies, lift pit, etc
•  Waterproofing on dry wall in wet areas, e.g, gypsum and cement board etc.
•  Walkways, terraces, planter boxes
•  Precast gable end walls
•  RC flat and roof terrace in built-up roofing systems (concealed applications)

Advantages

•  Single component - ready to use
•  Can be applied by brush, roller or spray
•  Quick drying
•  Elastomeric seamless membrane
•  Able to bridge cracks
•  Can be painted over with good quality acrylic paint.
•  Water-based formulation – Environmentally friendly

Surface Preparation

The substrates must be clean and sound, free of dust and loose particles. Remove laitance, oil, grease, mould release agents or any foreign contaminants which may inhibit adhesion from substrate by using wire brush, scabbler or other approved means. Where moss, algae or similar growths have occurred, treatment with suitable chemicals should be carried after the initial cleaning process followed by further washing.

It is recommended that a cement & sand fillet be formed at all corners to receive the waterproofing membrane.

Application

Stir QUICSEAL 102ECO manually before application. For horizontal and vertical surfaces, a roller, brush or spray gun, may be used to apply the membrane. Care must be taken to ensure that air is not entrapped in the membrane. 

Pre-treat QUICSEAL 102ECO on all corners, upturns and pipe penetrations with a brush followed by application to the general areas and allow to dry. Allow membrane to dry for approximately 2 hours before application of the second coat.

Apply the 2nd coat at right angles to the last coat of waterproofing membrane, allow it to cure for 24 hours before proceeding to conduct any flooding test.

Packing

Pack size : 24 kg pail

Coverage

Coverage : 1.3-1.5kg/m² /2 coats

Wet film thickness/ coat : 1.2 ± 0.1mm

Cleaning

Due to high adhesion strength of this product even on metals, it is advisable to wash tools with water before the product sets. After setting, cleaning can only be achieved by mechanical means.

Storage

The shelf life of QUICSEAL 102ECO is 12 months when stored unopened in a cool and dry place.